Connecting to the Pi
Ostatnio modyfikowane 2021/01/17 19:08 przez Stephan Robinig
Enable and Configure Raspberry Pi in Pocket Code
If you haven't already done so, you'll have to enable and configure your Raspberry Pi under Settings in "Raspberry Pi bricks".
- tick the check-box to enable Raspberry Pi bricks
- change the settings if necessary:
- enter IP-/Host-Address
- very often works as default host address"raspberrypi"
- if your RPi has a keyboard + monitor:
find out the IP-address from a terminal via ifconfig - your router might list all connected computers within the network
- if all of that fails: find out the IP-address via the nmap command
- Port
- the default is 10000 (don't change it unless you changed the script on the Raspberry Pi)
- GPIO version
- select the Raspberry Pi model you are using.
- enter IP-/Host-Address
After that you can add Raspberry Pi bricks into your project.